This Old House's water heater cost guide (updated June 2026) puts an installed tankless water heater at $2,100 to $4,000, with an average of about $2,800. Fixr's tankless guide (updated January 2025) lists gas units at $1,400 to $3,500 and electric units at $1,000 to $3,000 including labor. Gas units cost more because they need larger gas piping, a stainless vent and a condensate drain, and Fixr puts the whole-house unit alone at $450 to $1,500. Sacramento prices vary, and the specialist who visits your home quotes the real figure.
If you are still deciding whether tankless suits your house, start with the guide to tankless water heaters. This page only covers the cost. More Sacramento plumbing prices sit on the plumbing guide home page.
What is the average cost of a new tankless water heater for a whole house?
This Old House lists tankless labor at $800 to $1,500 and permits and inspections at $50 to $200. Installing, venting, gas piping and a permit make up the balance above the unit. Electric whole-house units can cost less to buy but may need a new circuit or panel upgrade.
| Setup | Range in the cited guide | Notes |
|---|---|---|
| Gas tankless, replacing a gas tank | $1,400 to $3,500 (Fixr) | Includes new vent and gas connection |
| Electric tankless, whole house | $1,000 to $3,000 (Fixr) | Often needs a heavy-duty circuit |
| Propane tankless | $1,400 to $3,500 (Fixr) | Needs a propane supply and regulator |
| Tank to tankless conversion | $1,000 to $4,000 (Fixr, 40-gallon guide) | Adds new gas line, vent, condensate drain |
| Remove old tank | $50 to $150 (Fixr) | Often included in the quote |
Ranges come from This Old House's water heater cost guide (updated June 2026) and Fixr's tankless guide (updated January 2025). Sacramento prices vary.
Typical plumber prices in Sacramento
This Old House lists labor for a tankless install at $800 to $1,500. Fixr's tankless guide says the install takes 6 to 10 hours at plumber rates of $75 to $130 an hour. Shorter jobs happen when the old unit sits in the same spot and the existing gas line is big enough.
Labor cost to install a water heater of any kind goes up when the plumber has to cut into walls, run a new vent through a roof or exterior wall, or pull a permit. Your overall quote usually shows labor, the unit, parts such as isolation valves and a vent kit, and the permit. Ask to see each line.
Installing a tankless unit is regulated work. California requires a contractor with the right California license for any job of $1,000 or more in labor and materials, and for any job that needs a permit. Gas and venting work needs a permit. The Contractors State License Board lets you look up a license online, including its status and any complaint disclosure.
What pushes the price up or down
Fuel type, gas line size, venting and electrical capacity decide most of the price. A tankless gas heater often needs a larger gas line than a tank heater, because it burns far more gas at once. A line that is too small starves the unit and it shuts down. Fixr says a new gas line can add as much as $800.
Other things that change the quote:
- Venting. Tankless gas units need special stainless or plastic venting rated for the unit. A long vent run or a new roof penetration adds cost.
- Electrical. Electric whole-house models often draw 120 amps or more, split over several breakers. If your panel is full or old, a panel upgrade may be needed, and an electrician can quote it.
- Size. Pick a unit by flow rate in gallons per minute. A family running two showers needs a bigger unit than a couple.
- Condensate drain. High-efficiency gas units produce acidic condensate. The plumber routes it to a drain, sometimes with a neutralizer.
- Water quality. Sacramento water is moderately hard. A scale filter or softener helps protect the heat exchanger.
- Location. A garage or exterior wall is cheaper than an attic or crawl space.
If you want the cost of an upgrade from a tank, the in-depth look at replacing a water heater with a tank unit shows what the cheaper path costs. For a comparison, read about tank versus tankless.
Do tankless water heaters save money?
They can save energy but rarely pay back the extra install cost quickly. The US Department of Energy says tankless units can last up to 20 years, against 10 to 15 for a tank. They only heat water when you use it, so they avoid the standby loss of a tank keeping 40 to 50 gallons hot all day.
Whether you save depends on your use. A household using a lot of hot water gets less benefit than one using a little, because the saving comes from not heating a full tank all day. Gas costs from PG&E and electric rates from SMUD differ, so the cheaper fuel for your address decides the monthly cost. A typical gas tankless unit saves a modest amount a year compared with a gas tank. Do the math with your own bill before you pay the extra up front.
What does maintenance cost?
Fixr's water heater repair guide lists $100 to $250 for a professional inspection, flush and cleaning of a water heater. A flush with white vinegar or a descaling solution clears mineral buildup from the heat exchanger. In Sacramento, many manufacturers suggest this once a year, and more often if the water is hard.
Maintenance matters because scale narrows the heat exchanger and shortens the unit's life. The US Department of Energy notes the same issue in its Building America guidance. Skip it and you may see error codes, weak flow or lukewarm water.
How do you compare tankless water heater quotes?
Ask each plumber to list the model, its flow rate, the vent type, the gas line size, the permit and what warranty comes with the unit and the labor. Quotes that differ by a lot often differ in vent work or gas line size, not in the unit.
A written quote should say whether the plumber is replacing the gas line, adding isolation valves and pulling the permit. Do not pay a large deposit upfront. California caps a down payment on a home improvement contract at the lesser of 10 percent or $1,000, and a good plumber follows that. For the other cost angle, see the cost of an on demand water heater for conversions and monthly running costs.
Questions people ask
How long does water heater tankless cost take?
Expect a tankless install to take 4 to 8 hours in one visit. A straight swap with the gas line already sized correctly is faster. A conversion from a tank, with a new vent, gas line and drain, can take a full day, and a panel upgrade for an electric unit may add a second visit.
What should I ask before I hire someone for water heater tankless cost?
Ask whether the quote includes the permit, the vent, the gas line upgrade and disposal of the old tank. Ask for the model number and flow rate, the labor warranty and who handles the inspection. Look up their contractor license on the Contractors State License Board site, and ask when the work could start.
Do I need to be home for water heater tankless cost?
Someone over 18 should be home to let the plumber in, approve any change, and sign off at the end. The water goes off for part of the day, so plan around showers. The plumber needs clear access to the old heater and the wall where the new one will mount.
Sources used
- US Department of Energy, Energy Saver guide (tankless lifespan)
- US Department of Energy, Building America guide to transitioning to a tankless water heater
- Contractors State License Board, hiring a contractor
- How Much Does Water Heater Installation Cost, This Old House (updated June 2026)
- Tankless Water Heater Installation Cost, Fixr (updated January 2025)
Last changed