Jump to content
Sactown Plumbing Guide

About the job · Sacramento

Electric water heater for homes in Sacramento

An electric water heater heats a tank with resistance elements on a 240 volt circuit, and it needs no gas line or vent. This page covers safety, running cost, sizing, tankless and heat pump options, and what a replacement costs in the Sacramento area.

An electric water heater inside a tidy hall closet

Tell us about your plumber job

Tell us about the job and a local specialist will get back to you with a quote.

Lets the business see where the job is before they quote.

An electric water heater is the simplest type to install: a tank, two heating elements, a thermostat and a 240 volt circuit. There is no flame, no flue and no gas line. Fixr's 40-gallon water heater guide (updated January 2026) lists $700 to $1,650 installed for an electric tank, and a heat pump model costs more ($1,600 to $5,000 in the same guide) but uses a fraction of the electricity.

If a heater has failed, start with the main water heater repair and replacement guide and then use this page to decide what to put in its place. The sections below answer the questions people ask most, from safety to cost to size.

Is an electric water heater safe?

Yes, when it is installed to code, sized correctly and fitted with a working temperature and pressure relief valve. Because an electric tank burns no fuel, it produces no carbon monoxide and carries no gas leak risk. The main hazards are scalding from a thermostat set too high and electric shock if someone opens the panel with the power on.

Keep these habits:

  • Set the thermostat to about 120 degrees Fahrenheit.
  • Turn off the breaker before opening an access panel, and never touch wiring live.
  • Test the relief valve and check its discharge pipe runs to a safe spot.
  • Strap the tank. California requires water heaters to be braced against earthquakes under Health and Safety Code section 19211, which points to the California Plumbing Code.
  • Never run an electric element in a tank that is not full of water. A dry element burns out fast.

Faults such as a tripping breaker, a hot panel or a scorched wire call for a plumber or an electrician right away.

Is it cheaper to heat water by gas or electric?

Gas is usually cheaper per unit of heat, but the gap depends on current PG&E gas rates and SMUD electricity rates for your home. A standard electric tank converts nearly all its electricity to heat, but electricity costs more per unit of energy than gas in most places. A heat pump water heater changes the answer, since it uses far less electricity than a standard electric tank.

Compare actual bills rather than guessing. Ask both utilities for current rates, estimate your hot water use, and run the numbers. Our page on electric vs gas water heaters lays out the installed cost, the efficiency difference and what a fuel switch requires. For heat pump models in particular, see water heater heat pump cost.

The U.S. Department of Energy describes heat pump water heaters as roughly two to three times as energy efficient as conventional electric resistance models. They work by pulling heat from surrounding air, so they like a space with open airflow, such as a garage, and they cool that space a little, which is a plus through a Sacramento summer. Check current SMUD and state incentive programs on their official sites, because they change.

How big an electric water heater do you need?

Size by the first-hour rating, not just the tank volume. As a rough guide, a 40 gallon tank suits two to three people, a 50 gallon tank suits three to four, and a larger family or a home with a soaking tub may need 50 to 80 gallons. The first-hour rating is printed on the yellow energy label and shows how much hot water the unit supplies in the first hour of heavy use.

A common question is whether a 40 gallon water heater is enough for a three bedroom house. Often it is, if two or three people live there and showers are spread through the morning. If three or four people shower close together, or you run the dishwasher and washing machine at peak times, 50 gallons is the safer choice. Our guide to the 50 gallon electric water heater covers that size, including cost and dimensions to check against your space.

Electric tanks generally use two 4,500 watt elements, an upper and a lower one, on a dedicated 30 amp, 240 volt circuit with the right wire gauge. A plumber or electrician checks that your existing circuit matches the new unit before ordering.

Do instant water heaters use a lot of electricity?

An electric instant (tankless) water heater uses no energy while idle, but when it runs it draws a very large amount of power. A whole-house electric unit can pull 100 amps or more at 240 volts, so many homes need a panel upgrade or a heavier service line. Over a year, total use depends on how much hot water you draw, and for low-use homes it can be lower than a tank.

For gas models, the U.S. Department of Energy says demand water heaters can be 24% to 34% more energy efficient than storage tanks in homes using 41 gallons or less of hot water a day, and 8% to 14% in homes using about 86 gallons. A DOE Building America guide says an electric tankless unit saves at best about 12% over an electric tank. Small point-of-use electric units, which serve a single sink or a far bathroom, need much less power and avoid long pipe runs. Fixr's tankless guide (updated January 2025) lists $1,000 to $3,000 for an installed electric tankless unit.

Can you run two showers with a tankless water heater?

It depends on the unit. A typical shower uses about 2 gallons per minute, so two showers need around 4 gallons per minute at the temperature you set. Electric tankless units usually can heat less water per minute than gas ones, so a single electric unit may struggle with two showers at once in winter, when the incoming water is cold.

Ask the plumber to size the unit on your coldest incoming water and your busiest hour. Where one unit is not enough, some homes add a second unit or a small unit near the far bathroom. For the full tankless story, read tankless water heater installation or the tank vs tankless comparison.

Why do plumbers not recommend tankless water heaters?

Many plumbers do install them, but they warn against specific situations: a house that was not set up for the gas line, vent or electric service, an undersized unit, hard water that scales the heat exchanger and a buyer expecting unlimited hot water for unlimited taps. The complaint is about fit and upkeep, not the technology itself.

In an all-electric Sacramento home, the real obstacle is often the panel. A whole-house electric unit needs large circuits, and a panel that is already full can mean a costly upgrade. In that case a heat pump tank or a standard electric tank may be the better match. A plumber who explains your options and quotes more than one is easier to trust than one who pushes a single product.

How long does an electric water heater last, and what maintenance does it need?

An electric tank typically lasts about 10 to 15 years, and sooner with heavy sediment or a spent anode rod. Maintenance is light: flush the tank once a year, check the relief valve, and have a plumber look at the anode rod every few years. Elements and thermostats are replaceable parts that often fail before the tank does.

See how long a water heater lasts and how to flush a water heater for the details. A drip from the relief valve discharge is a warning sign, covered in relief valve replacement. When it is time to replace, expect a permit: the City of Sacramento lists building permit and related fees for water heater replacement. For more topics start at the Sactown Plumbing Guide home page.

Questions people ask

Is a 40 gallon water heater enough for a 3 bedroom house?

Often yes for two or three people, and often not for four or more who shower around the same time. If your household has a soaking tub, a large shower or heavy laundry loads, step up to 50 gallons. Check the first-hour rating on the label rather than tank size alone, and ask the plumber to size it.

How long does electric water heater take?

Replacing an electric tank usually takes two to four hours: drain and remove the old unit, set and strap the new one, connect water and power, fill and test. If the circuit or the location changes, it takes longer. A permit inspection can happen on a separate visit. Hot water is typically back by the end of the day.

What should I ask before I hire someone for electric water heater?

Ask what the quote includes: permit, straps, relief valve and discharge pipe, disposal of the old tank and any circuit work. Ask for the plumber's license number and check it with the California Contractors State License Board. Ask about the warranty on labor and the unit, and for an itemized price in writing.

Read on

  • 50 gallon electric heater

    Electric water heater 50 gallon guide for Sacramento: who it suits, installed cost, repair kits, elements and thermostats, and what to do…

  • Heat pump heater cost

    Heat pump water heater cost in Sacramento: installed price ranges, how it compares with a standard electric water heater, and SMUD rebates…

Sources used

Last changed