Jump to content
Sactown Plumbing Guide

Costs ยท Sacramento

How much does a plumber cost in Sacramento?

Fixr's plumber cost guide lists $75 to $150 an hour and a $50 to $300 service call fee, with common repairs priced by the job. This page lists those figures and what to check before you hire.

A bathroom vanity with the cabinet open and pipes visible

Tell us about your plumber job

Tell us about the job and a local specialist will get back to you with a quote.

Lets the business see where the job is before they quote.

Fixr's plumber cost guide (updated January 2025) says plumber hourly rates run $75 to $150, with a national average of $90, and that many plumbers add a service call fee of $50 to $300. Small jobs such as replacing a faucet or clearing a drain are priced by the job (see the table below). Bigger jobs, such as a water heater or a sewer line, are quoted as a flat price. Sacramento prices vary, so these are national guide figures only. The plumber you hire quotes the real number after looking at the job.

Looking for the cheapest plumber near you? Cheapest is not always lowest cost, so this page shows how to find an affordable plumber without taking on risk. For the wider picture of plumbing help in the city, start from the Sactown Plumbing Guide home page.

How much does a plumber usually charge?

Fixr's plumber cost guide puts hourly rates at $75 to $150, plus parts, with a national average of $90. Many plumbers bill a minimum of one hour, and many charge a service call fee of $50 to $300 that covers the first part of the visit. Flat-rate pricing, where you get one price for the whole job, is common for standard repairs.

The table shows common jobs with the ranges each guide lists. Hourly, service call, drain, toilet, disposal, pipe leak and repipe figures come from Fixr's plumber cost guide (updated January 2025). The faucet figure comes from This Old House's plumbing cost guide (updated June 2026), the water heater figure from This Old House's water heater cost guide (updated June 2026), and the hydro jetting figure from Fixr's drain cleaning article (October 2026). Sacramento prices vary.

JobTypical price range
Service call or diagnosis$50 to $300
Hourly labor$75 to $150 (national average $90)
Unclog a sink or tub drain$100 to $500
Unclog a main sewer line$350 to $650
Hydro jetting a drain (hydrojet)$300 to $700 for an interior drain
Replace a faucet$150 to $600 to replace a faucet
Replace a toilet$400 to $800
Replace a garbage disposal$300 to $600
Repair a leaking pipe$150 to $350
Water heater replacement$1,200 to $2,300
Repipe a house$4,000 to $12,000 for about 2,000 square feet

Rough-in is the pipework installed in walls and floors before fixtures go in, and it depends on the layout. If you want hourly detail, the guide on what a plumber costs per hour goes deeper.

What changes the rate: the time of day, how hard the pipe is to reach, whether a permit is needed, the cost of parts, and the plumber's expertise. A plumber with experience in a hard job, such as a sewer line or a gas line, tends to charge more per hour than one doing a faucet swap.

What does an emergency plumber cost?

An emergency plumber costs more than the normal rate. Fixr's plumber cost guide gives about $150 an hour as the standard emergency rate, plus an emergency call-out flat fee of $200 to $300. Fixr's drain cleaning article (October 2026) says after-hours, weekend and holiday work often runs 1.5 to 2 times the standard rate. A burst pipe or a sewer backup at 2 a.m. is the typical case, and the first step is shutting the water off at the main.

A fair emergency quote still has itemized parts and labor. Be cautious if a plumber refuses to state a price over the phone, or if the price rises sharply once they are in your house. Ask for the call-out fee, the hourly rate after hours and the minimum charge before you say yes. To read about when after-hours help makes sense, see the guide to a 24 hour plumber and the page on plumber emergency.

Not every leak is an emergency. If the water is off at the main and nothing is flooding, waiting for a weekday visit often avoids the emergency premium. A burst pipe with water spraying is an emergency. A dripping trap under a sink is not.

How much does a leaky pipe cost to fix?

Fixr's plumber cost guide lists $150 to $350 to repair a leaking pipe, and more when the pipe is inside a wall or under a slab. A visible drip at a joint or a supply line is often the cheaper end. A hidden leak adds the cost of finding it and opening the wall, then patching it.

A simple compression fitting or a worn washer costs little. A pinhole leak in copper may need a section of pipe replaced. If the pipe is in a wall, expect drywall repair too. Finding the leak can cost $100 to $400 on its own, according to Fixr's slab leak guide (updated May 2025), which is covered in the page on leak detection cost. If a house has multiple leaks in old pipes, a repipe may cost less than repeated repairs.

How much is plumbing for a mobile home?

Plumbing for a mobile or manufactured home costs about the same hourly rate as a site-built house, but some jobs run higher because of tight access under the floor. Pipes are often plastic, and many mobile homes have a single main shut-off and a belly wrap under the floor.

Typical jobs include replacing a water heater, fixing a supply line and clearing a drain. Mobile home water heaters are sometimes a different size, so check before you buy. If the home sits on a rented lot, the park may control the main supply line and shut-off, so ask the park manager who owns which piece of pipe.

How much should I pay for a plumber?

Pay a price that is in line with the ranges above, written down before the work starts, with parts and labor separate. If you have three quotes and one is 40 percent lower than the others, find out why. It might be a smaller scope, a cheaper part or a plumber who does not plan to pull a permit.

California adds a few rules. A contractor's license is required for jobs of $1,000 or more in labor and materials, or for any job that needs a permit. The Contractors State License Board lets you look up a license online. Hire only someone whose license number shows as active, and ask for it in writing. California also caps a down payment on a home improvement contract at the lesser of 10 percent or $1,000, so be wary of a request for half the money up front.

Some plumbers advertise "cheap" or "affordable" rates and then add fees on arrival. The practical ways to keep the cost down are:

  • Get two or three written quotes for any job over $500.
  • Ask whether the service fee is waived or credited when you book the repair.
  • Book during regular hours.
  • Group small jobs into one visit.
  • Describe the problem and send photos so the plumber arrives with the right parts.
  • Ask what is included: permit, parts, disposal and a labor warranty.

For drain problems in particular, compare the price of snaking against drain cleaning with a camera, since the right method often decides the final bill.

Can you use a plumbing cost calculator?

A cost calculator can give a rough starting number, but it cannot see your pipes. Online estimators use averages for your area and job. Use one to check that a quote is within a normal range, then ask a local plumber to look at the job in person.

Questions people ask

How long does plumber cheap take?

A cheap plumber is not necessarily slower, but a quick fix may not last. Standard repairs take 1 to 3 hours. A water heater replacement takes half a day. Ask for a start window and an estimate of how long the job runs, and whether the plumber will need a second visit for parts.

What should I ask before I hire someone for plumber cheap?

Ask for their contractor license number and check it with the CSLB. Ask what is included in the price, whether they pull the permit, what the labor warranty covers, and whether the quote is written. Ask about fees for travel, after-hours work and parts markup.

Do I need to be home for plumber cheap?

Usually yes. An adult should let the plumber in, show the problem, approve extra charges and check the work at the end. If you cannot be home, ask whether a trusted adult can be there. Clear the area around the fixture so the plumber can reach it.

How much does it cost to become a plumber?

Most people become plumbers through an apprenticeship, where they earn a wage while they learn and take classes. Costs are mainly for tools, books and class fees, which differ by program. Contact the California Division of Apprenticeship Standards or a local union program for current figures, since fees differ from one program to the next.

Sources used

Last changed